Ice Mold Instructions

Directions for glacio Silicone Ice Trays

For Ice Ball Tray  

(Option #1)

  • Fill bottom tray 3/4ths full
  • Carefully place top tray into bottom tray, making sure all 6 sphere molds pop into place and press down until liquid comes out of holes (spillover on top lid is normal)
  • Make sure top and bottom tray are flush together
  • Place in freezer for a few hours or overnight (when moving tray, grab lengthwise)
  • Grab ends of tray mold, twist side to side to break up ice

(Option #2)

  • Make sure top and bottom trays are flush together by popping in all 6 sphere molds into place
  • Using a small stream of water, fill each sphere mold from the top until full (spillover on top lid is normal and won't affect the ice balls)
  • Place in freezer for a few hours or overnight (when moving tray, grab lengthwise)
  • Grab ends of tray mold, twist side to side to break up ice

For Square Ice Tray

  • Fill
  • Place in freezer for a few hours or overnight
  • Push one ice cube at a time from the bottom

(Trouble getting ice out? Run water over ice for 1-2 seconds and twist tray side to side) 

 *Wash both trays before use (Dishwasher safe)  

For Daily Craft Cocktail Recipes, find and like us on Facebook